Author Topic: Welder  (Read 166 times)

Offline Runner

  • Forum User
  • Posts: 2489
Re: Welder
« Reply #15 on: February 22, 2021, 01:57:27 PM »
I would say get at least a 60CF. I have a pony bottle (I can't remember the size, think its 20-30CF) but it's way to small. I do plan to keep it as a spare, because you always seem to run out on the middle of a project.

I'm likely going to go the route of a 80CF bottle. Since I'm relatively close to refill places, I'll hold off on the backup bottle for now.
2004 LJ - Built to wheel, but hides in the garage :(

Offline highlandercj-7

  • Forum User
  • Posts: 1882
Re: Welder
« Reply #16 on: February 22, 2021, 02:22:46 PM »
Rule of thumb is the bigger the better  8) The last time I had mine filled the guy asked if I wanted to trade up. Since I already have the back up bottle I am not trading it in. So I just plan to buy a large bottle out right.


HighlanderCJ-7

 

Officers:

President: Donnie Herrity (Jeepin_Donnie) | Vice President: Hiam Agha (BLACKHAWKJEEP)| Secretary: Robyn Alley (sticksout)
Treasurer: Danille Wilson (TJ Girl) | Member-at-large: Scott Posti (Nacho)

Board of Directors:
Dave Plummer (HAWAIICJ) | Sean McCready (Unl1mtd)
Jeff Wilson (jwilson2598) | Aaron Thomson (Jeep Freak) | Dain Wilson (Gr8Dain)

Founding Fathers:
 Jason Markvart (LNDSRK)  | Steve Scott (Islander90) | Josh Storer (Jastor)| Mike Finelli (BiggMike) | John Harper (Opie) | Andrew Harvin (HarvinJeep)

Disclaimer Statement:
All images from NoVaJeepers.net are exclusive to the Northern Virginia
Jeepers Association. Any reproduction of exclusive Northern Virginia
Jeepers Association material is strictly prohibited without written
consent of the Northern Virginia Jeepers Association. Jeep,
Wrangler, Cherokee, Commander, Compass, Patriot, Liberty, Unlimited,
Rubicon, SRT, HEMI and Grand Cherokee are copyrighted and trademarked
to Chrysler LLC. NoVaJeepers.com, Northern Virginia Jeepers Association
is not in any way associated with the Chrysler LLC.